Page 19 - NG-1 1150, NG-1 1500, NG-1 2000, NG-1 3000 - Stand-Alone Nitrogen Generator System Installation Manual

The cabinet includes pre-punched holes in the feet for floor mounting and holes in the back panel for wall mounting using standard anchors.
NOTE: When floor mounting the generator cabinet, Ensure the cabinet is firmly anchored to a flat/level surface.
When wall mounting the generator cabinet, Ensure the cabinet is firmly anchored to a wall, the wall is structurally sound, and cable of supporting the generator cabinet.
Step 2: Mounting the air compressor
The air compressor is designed to be mounted directly to the floor at the appropriate location. Several factors should be considered in choosing the proper mounting location for air compressor:
· Access to required power supply (dedicated circuit)
· Access to nitrogen generator
· Access to drain for the condensate discharge line
· Clearance around the air compressor for servicing the equipment · Cleanliness of the environment and air intake
The air compressor includes pre-punched holes in the feet for floor mounting using standard anchors.
NOTE: 1. Ensure the air compressor is firmly anchored to a flat/level surface.
2. Install vibration pads between mounting feet of the air compressor and the floor. NOT Installing
vibration pads will void manufacturer’s air compressor warranty.
Step 3: Nitrogen Generator Power Supply
The TYCO Nitrogen Generator requires a dedicated power supply to prevent interaction with other equipment. The incoming power supply line is connected to the top of the terminal blocks inside the nitrogen generator cabinet. The terminal connections are labeled L1, N, and G.
Required nitrogen generator power supply: 120VAC/1 phase/60Hz (220-240VAC/1 phase/50Hz) dedicated 20 amp circuit.
120 VAC/60Hz
120VAC/1 Phase 60 Hz Connections
220-240VAC/1 Phase 50 Hz Connections
L1 N G
L1 N G
TFP1275
Page 18 of 84
220-240VAC/50Hz