Page 80 - NG-1 100, NG-1 250, NG-1 500 - Wall-Mounted Nitrogen Generator System Installation Manual
P. 80

INSPECTION, TESTING, AND MAINTENANCE REPORT
All maintenance is to be performed by qualified personnel. Prior to any system maintenance on the nitrogen generation system, ensure that the nitrogen generator is isolated from the compressed air supply and all system risers. Ensure that the nitrogen generation system and the associated piping that is to be manipulated is completely depressurized prior to performing any maintenance. Failure to do so can result in system damage and/or personal injury.
 Customer
City
Date
        Address
Inspector
        Customer No.
      State
  ZIP
Contract No.
   Inspection No.
             Sprinkler System Information
 (psig)
  N/A
  Verified
  Qty of Systems
    AMD Set Pressure
        AMD Manufacturer
      Low Air Alarm Pressure
            AMD Model No.
    System Trip Pressure
          Nitrogen Generator Air Compressor Information
  Cut-In (psig)
  Cut-Out (psig)
    N/A
  Verified
Manufacturer
    Model No.
                 Serial No.
            Existing/Backup Air Compressor Information
Manufacturer
Cut-In (psig)
Cut-Out (psig)
          N/A
Verified
    Model No.
        Serial No
                   Nitrogen Generator Information
  Cut-In (psig)
  Cut-Out (psig)
    N/A
  Verified
Manufacturer
      Model No.
             Serial No.
           Air Compressor – Quarterly Maintenance
   Hrs.
   N/A
   Verified
   Verify run time (hours) on air compressor (use nitrogen generator hour meter)
Verify compressor is turning on/off at low/high pressure
Verify pressure gauges are in working order (replace as necessary)
Verify all manual valves fully open and close (repair or replace as necessary)
Verify all manual valves operate smooth-clean and un-corroded (repair/replace if needed) Check air compressor filter(s) (clean or replace as necessary)
Check electrical connections in control box and pressure switch (repair as necessary) Check air compressor and supply piping for leaks (repair as necessary)
Check drive belt and drive belt tension (repair or replace as necessary) Replace crankcase oil (3 months or 500 hours whichever comes first)
Air Compressor – Oil-Less
Rebuild compressor cylinders (5,000 hours)
                       Air Compressor – Splash Lubricated
                     TFP1273
Page 79 of 80





































   77   78   79   80   81